Manifold Absolute Pressure (MAP) sensor - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 Disconnect the sensor wiring plug. Do not pull on the wiring.
3 Disconnect the vacuum hose from the sensor.
4 Remove the two securing screws and withdraw the sensor from the engine compartment bulkhead.
Refitting
5 Refitting is a reversal of removal, but note
that the fuel trap in the vacuum line between
the inlet manifold and the sensor should be
fitted with the white end towards the sensor.
See also:
Braking system
General information and precautions
General information
The braking system is of the dual circuit
hydraulic type. The front and rear circuits are
operated independently from a tandem
master cylin ...
Steering gear - removal, overhaul and refitting
Removal
Note: New tie-rod balljoint split-pins must be
used on refitting.
1 Set the front roadwheels in the straightahead
position.
2 Raise the front of the vehicle and fit stands
(see “Jacking ...
Timing belt - removal, refitting and adjustment
Removal
Note: From April 1988 (build code JG) a
modified timing belt tensioner incorporating a
larger diameter tensioner roller was
introduced, and from October 1988 an
improved timing belt was u ...