Air Charge Temperature (ACT) sensor - removal and refitting
Removal
1 The air charge temperature sensor is
screwed into the inlet manifold (see
illustration).
14.1 Air charge temperature sensor - 1.6 EFI engine
A Wiring plug B Sensor
2 Disconnect the battery negative lead.
3 Disconnect the sensor wiring plug. Do not pull on the wiring.
4 Unscrew the sensor from the inlet manifold.
Refitting
5 Refitting is a reversal of removal, but apply
suitable sealer to the sensor threads.
See also:
Fuel tank - removal and refitting
The procedure is as described in Part A of
this Chapter for carburettor engines. ...
Brake hydraulic system (conventional braking system) - bleeding
Caution: Refer to the
precautions in Section 1.
General
1 If any of the hydraulic components in the
braking system have been removed or
disconnected, or if the fluid level in the
reservoir has b ...
Braking system
The braking system is of the dual circuit hydraulic type with
disc brakes at the front and drum brakes at the rear. A diagonally split dual
circuit hydraulic system is employed in which each circu ...