Engine Coolant Temperature (ECT) sensor - removal and refitting
Removal
1 The sensor is screwed into the cylinder
block below the inlet manifold.
2 Disconnect the battery negative lead.
3 Drain the cooling system as described in Chapter 1.
4 Disconnect the sensor wiring plug.
5 Unscrew the sensor from the cylinder block.
Refitting
6 Refitting is a reversal of removal, but on
completion refill the cooling system as
described in Chapter 1.
See also:
Diagram 3: 1980-86 Ancilliary circuits all models
Diagram 3: 1980-86 Ancilliary circuits all models ...
Power steering pump - removal and refitting
Note: New power steering fluid hose O-rings
will be required when refitting.
All engines except 1.8 litre (R6A)
CVH and 2.0 litre DOHC
1 Place a suitable container under the power
steering pump, ...
Contact breaker points adjustment - models with contact breaker
distributor (Every 6000 miles or 6 months)
1 Spring back the retaining clips or undo the
screws as appropriate and lift off the
distributor cap.
2 Withdraw the rotor arm from the distributor
shaft.
3 Using a screwdriver, gently prise the
...