Fuel evaporative emission control system components (Central Fuel Injection/CFI engines) - removal and refitting
Carbon canister
Removal
1 The carbon canister is located behind the
bumper, under the front right-hand wheelarch
(see illustration).
5.1 Carbon canister location (wheelarch liner removed) - CFI engine
2 Disconnect the battery negative lead.
3 Remove the wheelarch liner.
4 Disconnect the pipe from the carbon canister.
5 Remove the screw securing the canister to the mounting bracket, and withdraw the canister.
Refitting
6 Refitting is a reversal of removal.
Carbon canister purge solenoid
Removal
7 The solenoid is located near the bulkhead
on the right-hand side of the engine
compartment (see illustration).
5.7 Carbon canister purge solenoid location - CFI engine
A Canister purge
solenoid
B Wiring plug
C Hose
8 Disconnect the battery negative lead.
9 Disconnect the solenoid wiring plug.
10 Disconnect both hoses from the solenoid, noting their locations, then withdraw the solenoid from the vehicle.
Refitting
11 Refitting is a reversal of removal.
See also:
Inlet manifold - removal and refitting
Note: A new gasket will be required on
refitting.
Carburettor models
Removal
1 Disconnect the battery negative lead.
2 Remove the air cleaner as described in Part
A of this Chapter.
3 Refer to ...
Multi-function lever
Windshield wiper:
For intermittent wiping, move the
control down one position and
rotate the wiper switch to the
desired position.
For low speed wiping, move the
control down two positio ...
Heater motor - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 Where necessary, unclip the brake servo
vacuum hose for improved access.
3 On models from 1987, unclip the
windscreen washer hoses and wiring fro ...