Starter motor brushes - renewal
1 Starter motor brush renewal is a relatively difficult procedure, requiring skill in the use of a soldering iron. It should also be borne in mind that if the starter motor has been in service long enough to wear the brushes out, the rest of the unit is likely to be well worn also. In such a case the best course is to obtain a new or reconditioned starter motor.
2 For further advice on brush renewal and on starter motor overhaul in general, consult an auto electrical specialist.
See also:
Fuel pump - testing
Caution: Refer to the
precautions in Section 1 before
proceeding.
Mechanical pump
1 On SOHC engines, the fuel pump is located
on the left-hand side of the cylinder block,
next to the oil filter. ...
Exhaust manifold - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 Remove the air cleaner and pull the hot air
pick-up pipe from the exhaust manifold hot air
shroud.
3 Remove the securing screws (1 screw on
DOHC ...
Auxiliary shaft - removal, inspection and refitting
Note: A new gasket should be used when
refitting the auxiliary shaft cover (see text).
Removal
1 Remove the timing belt and the auxiliary
shaft sprocket.
2 Remove the distributor.
3 Remove the m ...