Distributorless Ignition System (DIS) components - removal and refitting
Electronic modules 1 Refer to Section 6.
DIS coil
2 Refer to Section 4.
Engine speed sensor
Removal
3 Disconnect the battery negative lead.
4 Disconnect the sensor wiring plug (see illustration).
7.4 Disconnecting the engine speed sensor wiring plug - DIS
5 Remove the securing screw and withdraw the sensor.
Refitting
6 Refitting is a reversal of removal.
Engine Coolant Temperature
(ECT) sensor
Removal
7 The ECT sensor is screwed into the inlet
manifold (see illustration).
7.7 Engine coolant temperature sensor location (arrowed) - DIS
8 Disconnect the battery negative lead.
9 Partially drain the cooling system as described in Chapter 1.
10 Disconnect the sensor wiring plug.
11 Unscrew the sensor from the inlet manifold.
Refitting
12 Refitting is a reversal of removal, but on
completion top up the cooling system as
described in “Weekly checks”.
See also:
Exhaust emission control system components - removal and
refitting
Carburettor engines
Spark delay/sustain valve
Removal
1 Disconnect the vacuum lines at the valve
and remove the valve from the engine.
Refitting
2 When refitting a spark delay valve it must
be ...
Fuel tank - removal and refitting
The procedures are the same as described
in Part A of this Chapter for carburettor
engines, but in addition disconnect the fuel
tank-to-fuel pump hose from the rear face of
the tank. ...
Emission control system
Your vehicle is equipped with various emission control components and a
catalytic converter which will enable your vehicle to comply with
applicable exhaust emission standards. To make sure that the ...