Handbrake lever - removal and refitting
Removal
1 Chock the front wheels, raise and support
the vehicle at the rear using stands (see
“Jacking and Vehicle Support”) then release
the handbrake.
2 Working underneath, extract the spring clip and clevis pin and disconnect the primary cable from the equaliser.
3 From inside the car detach the handbrake warning switch.
4 Disconnect the cable from the handbrake lever by extracting the clip and clevis pin (see illustration).
10.4 Removing handbrake lever clevis pin and clip
5 Unscrew the lever securing bolts and remove the lever.
Refitting
6 Refitting is the reverse sequence to
removal. On completion adjust the handbrake
cable, if necessary, as described in Section 8.
See also:
Cold start valve - removal and refitting
Note: Refer to the precautions at the end of
Section 1 before proceeding.
K-Jetronic system
Removal
1 Disconnect the battery earth lead.
2 Detach the electrical wiring multi-plug from
the valve ...
Waste gate solenoid control valve - removal and refitting
Removal
1 The solenoid control valve is mounted on a
bracket located underneath the ignition
distributor (see illustration).
21.1 Waste gate solenoid control valve location (arrowed)
2 Disconne ...
Seat belts - removal and refitting
Front belt - 3-door models
Note: Note the fitted sequence of any plates,
washers and spacers when unbolting the seat
belt anchors.
Removal
1 Slide the belt stalk cover upwards to
expose the anch ...