Braking system warning lamps and electrical switches - removal and refitting
General
1 All models are fitted with a low fluid level
warning switch in the master cylinder reservoir
cap and a brake pedal stop-lamp switch.
2 Some versions have front disc pad wear sensors and a handbrake “ON” warning switch.
3 Warning indicator lamps are mounted on the instrument panel. Their renewal is covered in Chapter 12.
Handbrake “ON” warning lamp
switch
4 The handbrake “ON” warning switch is
attached to the handbrake lever and can be
removed after disconnecting the wiring and
undoing the retaining screw (see illustration).
18.4 Removing handbrake warning switch
Stop-lamp switch 5 The stop-lamp switch can be removed by disconnecting the leads and unscrewing the locknut which holds the switch to its bracket under the facia (see illustration).
18.5 Brake stop-lamp switch locknut location (arrowed)
6 When fitting the switch, adjust its position by screwing it in or out so that it does not actuate during the first 5.0 mm of pedal travel.
See also:
Engine/manual gearbox assembly - reconnection and refitting
1 Reverse the procedure described in Section
11, noting the following points.
2 Before attempting to reconnect the engine
to the gearbox, check that the clutch friction
disc is centralised. This i ...
Air cleaner inlet air temperature control check (Every 24 000 miles (40 000
km) or 2 years)
SOHC and DOHC carburettor
models
1 A vacuum pump will be required to test the
control components.
2 To check the operation of the air
temperature control, the engine must be cold.
First observe ...
Contact breaker points renewal (Every 12 000 miles or 12
months)
1 Spring back the retaining clips or undo the
screws as appropriate and lift off the
distributor cap.
2 Withdraw the rotor arm from the distributor
shaft.
3 On the Bosch distributor disconnect th ...