Rear shock absorbers (Van models) - removal, testing and refitting
Removal
1 Raise and support the rear of the vehicle on
stands (see “Jacking and Vehicle Support”).
Place a jack beneath the rear axle tube and just raise it slightly.
2 Disconnect the shock absorber lower mounting by unscrewing the nut and pivot bolt.
3 Unbolt the top mounting bracket from the body and withdraw the unit (see illustration).
11.3 Removing the rear shock absorber top mounting bracket - Van models
4 Undo the nut and pivot bolt to separate the mounting bracket from the shock absorber.
Testing
5 Proceed as described in Section 10.
Refitting
6 Refitting is a reversal of removal, but if a
new unit is being installed, prime it first in a
similar way to that described for testing.
See also:
Pistons and connecting rods - removal and refitting
Removal
1 Remove the sump and the cylinder head.
2 Check the big-end bearing caps for
identification marks and if necessary use a
centre-punch to identify the caps and
corresponding connecting ro ...
Front suspension lower arm (pressed steel type) - removal,
overhaul and refitting
1 The pressed steel type suspension is only
fitted to pre-May 1983 1.1 litre models (see
illustration).
4.1 Pressed steel type lower arm components
A Lower arm
B Tie-bar
C Retaining bolt
D Ba ...
Vehicle loading
Before loading a vehicle, familiarize yourself with the following terms:
Base Curb Weight: Weight of the vehicle including any standard
equipment, fluids, lubricants, etc. It does not include oc ...