Rear roadspring (Saloon and Estate models) - removal and refitting
Removal
1 Raise the rear of the car and support it on
stands (see “Jacking and Vehicle Support”).
Remove the roadwheel.
2 Support the suspension lower arm by placing a jack beneath the spring seating.
3 On models equipped with a rear anti-roll bar disconnect the bar from the shackles by levering them apart with a screwdriver (see illustration).
13.3 Anti-roll bar-to-lower arm shackle attachment (arrowed)
4 Undo the nut and remove the lower arm inboard pivot bolt (see illustration).
13.4 Lower arm inboard pivot nuts and bolts (arrowed) - Saloon and Estate
models
5 Slowly lower the jack beneath the arm and remove the spring and insulator pad.
Refitting
6 Refitting is the reverse sequence to
removal. If applicable the plastic sleeved end
of the coil spring must be at the upper end
when fitted. Tighten all nuts and bolts to the
specified torque with the car standing on its
roadwheels.
See also:
Windscreen and fixed window glass - removal and refitting
Windscreen
Note: The average DIY mechanic is advised to
leave windscreen removal and refitting to an
expert. For the owner who insists on doing it
himself, the following paragraphs are given.
Rem ...
Exhaust gas oxygen (HEGO) sensor (2.0 litre DOHC/1.6 & 1.8 litre (R6A type)
CVH) - removal and refitting
Note: Do not touch the tip of the HEGO
sensor as this will drastically shorten its
service life.
Note: A new sealing ring should be used on
refitting.
Removal
1 Ensure that the engine and the ex ...
Horn switch assembly - removal and refitting
1 Disconnect the battery negative lead.
Switch
Models up to 1987
2 Pull the trim insert from the centre of the
steering wheel, and disconnect the lead from
the horn push.
3 Disconnect the two le ...