Rear suspension lower arm (Saloon and Estate models) - removal and refitting
Removal
1 Raise the rear of the car and support it on
stands (see “Jacking and Vehicle Support”).
2 On cars equipped with the anti-lock braking system, refer to Chapter 9 and remove the load apportioning valve adjusting bracket from the lower arm.
3 If an anti-roll bar is fitted, disconnect the shackles from the lower arm by levering them apart with a screwdriver (see illustration 13.3).
4 Support the lower arm using a jack located beneath the roadspring.
5 Undo the nut and remove the arm inboard pivot bolt.
6 Undo the nut, remove the outboard pivot through-bolt then lower the jack and remove the spring and insulator pad.
7 Withdraw the lower arm from the car.
Refitting
8 Refitting is the reverse sequence to
removal, bearing in mind the following points:
a) If applicable the plastic sleeved end of the
coil spring must be at the upper end
when fitted.
b) Tighten all nuts and bolts to the specified torque with the car standing on its roadwheels.
c) On cars equipped with the anti-lock braking system, refit the load apportioning valve adjusting bracket as described in Chapter 9.
See also:
Facia - removal and refitting
Pre-1986 models
Removal
1 Disconnect the battery negative lead.
2 Remove the under-dash cover panels.
3 Refer to Chapter 10 and remove the
steering column assembly.
4 Refer to Chapter 12 and rem ...
Ignition system electronic modules - removal and refitting
Amplifier module - electronic
breakerless system
Removal
1 The amplifier module is located on the side
of the distributor (see illustration).
6.1 Electronic amplifier module locations
A Early ...
Opening rear quarter window - removal and refitting
Removal
1 Remove the rear pillar interior trim panel.
2 Remove the two screws securing the
window catch to the body (see illustration).
26.2 Opening the rear quarter window catch
A Cap
B Retai ...