Steering tie-rod outer balljoint - renewal
1 If as the result of inspection the tie-rod outer balljoints are found to be worn, remove them as described in Section 20.
2 When the balljoint nuts are unscrewed, it is sometimes found that the balljoint taper pin turns in the eye of the steering arm to prevent the nut from unscrewing. Should this happen, apply pressure to the top of the balljoint using a length of wood as a lever to seat the taper pin while the nut is unscrewed. When this condition is met with, a balljoint extractor is unlikely to be required to free the taper pin from the steering arm.
3 With the tie-rod removed, wire brush the threads of the tie-rod and apply grease to them.
4 Screw on the new balljoint to take up a position similar to the original. Due to manufacturing differences, the fitting of a new component will almost certainly mean that the front wheel alignment will require some adjustment. Check this as described in Section 27.
5 Connect the balljoint to the steering arm, as described in Section 20.
See also:
Manual heating and air conditioning system (if equipped)
Fan speed control
Controls the volume of air circulated
in the vehicle.
Temperature control knob
Controls the temperature of the
airflow inside the vehicle.
Mode Selector Control
Control ...
Headlamps and auxiliary lamps - beam alignment
The headlamps are adjustable individually
for both horizontal and vertical alignment from
within the engine compartment. The auxiliary
lamp adjustment is carried out by slackening
the lamp mountin ...
Air cleaner - removal and refitting
The procedure is similar to that described in
Part B of this Chapter for models with
mechanical fuel injection. ...