Bonnet release cable - removal and refitting
Removal
1 Working inside the vehicle, extract the three
screws and remove the steering column
shroud. Open the bonnet. If the cable is broken,
the release latch must be operated using a
suitably shaped bar through the grille aperture.
2 Extract the single screw and remove the cable bracket from the steering column.
3 Working within the engine compartment, pull the cable grommet from the bonnet latch bracket and then disengage the cable end fitting from the latch (see illustration).
8.3 Bonnet cable attachment at latch and bracket (arrowed)
4 Unclip the cable from the side of the engine compartment.
5 Withdraw the cable through the engine compartment rear bulkhead into the vehicle interior.
Refitting
6 Refitting is a reversal of removal.
See also:
Front suspension lower arm inner pivot bush - renewal
1 To improve access, raise the front of the
vehicle on ramps. Apply the handbrake.
2 Unscrew and remove the nut, washer and
pivot bolt securing the relevant lower arm to
the crossmember.
3 Remove ...
Door - removal and refitting
Front door
1 On models with electric mirrors, electric
windows, central-locking, door-mounted
speakers, or “door ajar” sensors, remove the
trim panel and disconnect the wiring inside
the door. Wi ...
Hydraulic unit (ABS) - removal and refitting
Note: A new gasket must be used between
the hydraulic unit and the bulkhead on
refitting.
Caution: Refer to the
precautions in Section 1.
Removal
1 Disconnect the battery negative lead.
2 Depre ...