Tailgate - removal and refitting

Removal
1 Remove the trim panel (Section 32).

2 Disconnect the wiring from the heated rear window element, radio aerial, wiper motor tailgate speakers and tailgate lock motor as applicable (see illustration).

15.2 Electrical connections at the tailgate (1986 model shown)
15.2 Electrical connections at the tailgate (1986 model shown)

A Wiper motor
B Radio aerial connection C Feed and relay connectors D Earthing point

3 Tie a strong cord to the end of each separate wiring loom. Pull out the flexible grommets and withdraw the wiring looms until the cords appear. Untie the looms, leaving the cords in the tailgate.

4 Repeat this procedure for the washer supply pipe.

5 With an assistant supporting the tailgate, prise off the stout clips or release the pegs and disconnect the support struts from the tailgate (see illustration).

15.5 Releasing tailgate strut retaining clip
15.5 Releasing tailgate strut retaining clip

6 From the top edge of the tailgate aperture, remove the weatherstrip. Release the headlining clips from the flange.

7 Undo the screws and remove the pillar trim on each side, then pull the headlining down for access to the hinge bolts.

8 With the tailgate supported, undo the nuts from the hinge bolts and remove the tailgate.

Refitting
9 Refitting is a reversal of removal. Adjust the position of the tailgate in the aperture at the hinge bolts and the closing action at the striker plate.

    See also:

    Pistons and connecting rods - examination and renovation
    1.8 litre (R2A type) 1 Examine the pistons for ovality, scoring, and scratches. Check the connecting rods for wear or damage. 2 The gudgeon pins are an interference fit in the connecting rods, an ...

    Bonnet - removal and refitting
    Removal 1 Open the bonnet and support it on its stay. 2 Disconnect the screen washer pipe on the underside of the bonnet lid (see illustration). 7.2 Disconnecting the windscreen washer fluid pip ...

    Fuel evaporative emission control system components (Central Fuel Injection/CFI engines) - removal and refitting
    Carbon canister Removal 1 The carbon canister is located behind the bumper, under the front right-hand wheelarch (see illustration). 5.1 Carbon canister location (wheelarch liner removed) - CFI ...