Body exterior fittings - removal and refitting
Spoilers and wheel arch
deflectors
Removal
1 The spoilers and wheel arch deflectors
fitted to XR3, XR3i, Cabriolet and RS Turbo
models are secured by screws, rivets and
clips, or a combination of all three.
2 The screw and rivet fasteners are concealed under blanking plugs which are prised out to gain access to the screw or rivet as applicable (see illustrations). These can then be drilled out or unscrewed and the spoiler or wheel arch deflector withdrawn.
25.2a Front spoiler attachments - XR3 models
A Retaining screws B Retaining pegs
25.2b Front wheel arch extension attachments - RS Turbo models
A and B Rivets
C Screws
D Screw cap
Refitting 3 Refitting is a reversal of removal.
Body adhesive emblems and
mouldings
Removal
4 The radiator grille emblem, the front wing
motif, the tailgate emblems and the body side
mouldings are all of the self-adhesive type.
5 To remove these devices, it is recommended that a length of nylon cord is used to separate them from their mounting surfaces (see illustration).
25.5 Removing tailgate adhesive badge
Refitting 6 New emblems have adhesive already applied and a protective backing. Before sticking them into position, clean off all the old adhesive from the mounting surface of the vehicle.
See also:
Heater unit - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 If the coolant is still hot, release the
pressure in the system by slowly unscrewing
the expansion tank cap. Place a thick rag over
the cap to pr ...
Engine dismantling, examination, renovation and reassembly - general
information
Dismantling
1 Refer to Chapter 2, Part A, Section 18,
paragraphs 1 to 8 inclusive.
2 A suitable selection of splined and Torx
sockets will be required to remove many of
the bolts when dismantling ...
EEC IV system components - removal and refitting
Note: Procedures for removal and refitting of
the ignition system components and
electronic module are given elsewhere in the
relevant Sections of this Chapter.
Engine coolant temperature
sensor
...