Exterior lamps - removal and refitting
Headlamp
Removal
1 On pre-1986 models, remove the radiator
grille as described in Chapter 11.
2 Working in the engine compartment, disconnect the headlamp wiring multi-plug and remove the sidelamp bulbholder.
3 Rotate the side and upper plastic retaining clip heads through 90° to release the headlamp mountings (see illustrations).
7.3a Releasing the headlamp side plastic retaining clip head
7.3b Headlamp upper plastic retaining clip head (arrowed)
4 With the headlamp unit released, pull it sharply forward off its lower ballstud.
Refitting
5 Refitting is a reversal of removal.
Front direction indicator lamp
Removal
6 Working inside the engine compartment
disconnect the indicator bulb holder from the
lamp.
7 Remove the headlamp as described above.
8 Remove the headlamp upper plastic retaining clip then unscrew the ball-headed bolt (see illustrations).
7.8a Removing the retaining clip . . .
7.8b . . . and the ball-headed bolt
9 Remove the lower adjuster by turning the collar (see illustrations).
7.9a Release the adjuster by turning the collar (arrowed)
7.9b . . . then remove the adjuster
10 Release the side spring clip, then pull the lamp out at the bottom to disengage the upper tangs (see illustration).
7.10 Release the direction indicator side spring clip
Refitting 11 Refitting is a reversal of removal.
Rear lamp
Removal
12 Remove the bulbholder(s) as described in
Section 5.
13 Remove the lamp retaining screws or nuts as applicable, and remove the lamp.
Refitting
14 Refitting is a reversal of removal.
See also:
Rear hub bearings - renewal
1 Raise and support the rear of the vehicle on
stands (see “Jacking and Vehicle Support”).
Remove the roadwheel and release the
handbrake.
2 On fuel-injected models and Van versions
undo the reta ...
Deceleratio sensitive valve (all models with conventional braking system) - removal and refitting
Caution: Refer to the precautions in Section 1.
Removal
1 The deceleration sensitive valve is located on the left-hand side of the engine compartment (see illustrations).
23.1a Early type decele ...
Seats - removal and refitting
Front seat
1 Slide the seat fully forwards, and on seats
with height adjustment unhook the tension
spring from the rear crosstube. Where
applicable, disconnect the wiring from the
seat heating pa ...