Windscreen wiper motor and linkage - removal and refitting
Removal
1 Remove the wiper arms and blades as
described in Section 17.
2 Disconnect the battery negative terminal.
3 Remove the nut covers, the fixing nuts, washers and spacers from the pivot shafts.
4 Disconnect the wiper motor wiring at the multi-pin plugs.
5 Unscrew the two fixing bolts and withdraw the motor complete with linkage from the engine compartment (see illustration).
18.5 Windscreen wiper motor fixing bolts (arrowed)
6 Remove the spacers from the pivot shafts.
7 The motor can be separated from the linkage by removing the nut from the crankarm and then unbolting the motor from the mounting.
Refitting
8 Refitting is a reversal of removal, but
connect the motor crankarm when the link is
aligned with it as shown (see illustration).
18.8 Windscreen wiper crankarm alignment for refitting
See also:
Fuel injectors - removal and refitting
Caution: Refer to the
precautions in Section 1 before
proceeding.
Note: A tachometer and an exhaust gas
analyser will be required to check the idle
mixture on completion. New seals and
retaining ...
Throttle housing - removal and refitting
Note: During manufacture the throttle plate is
adjusted so that it is fractionally open, to avoid
the possibility of it jamming shut, and it must
not be repositioned. Idle speed adjustment is
prov ...
Heating and ventilation system - description
The heater is of the type which utilises
waste heat from the engine coolant. The
coolant is pumped through the matrix in the
heater casing where air, force-fed by a duplex
radial fan, disperses th ...