Crankshaft front oil seal - renewal
Note: A suitable puller will be required to remove the crankshaft pulley. A new crankshaft pulley bolt, and a new lower timing chain cover gasket, must be used on refitting.
1 The crankshaft front oil seal is located in the lower timing chain cover.
2 If the engine is in the car, carry out the
following operations:
a) Disconnect the battery negative lead.
b) To improve access, remove the radiator. It will be difficult to remove the crankshaft pulley with the radiator in place.
c) On fuel injection models, remove the air inlet hose, plenum chamber, and air cleaner lid as an assembly.
3 Proceed as described in paragraphs 3 to 8 of Section 15.
4 With the lower timing chain cover removed, prise the old oil seal from the cover using a screwdriver, and drive in the new seal using a suitable metal tube. Make sure that the seal lip faces into the engine. Take care not to damage the timing chain cover.
5 Refit the lower timing chain cover as described in paragraphs 31 to 39 of Section 15.
6 If the engine is in the vehicle, reverse the operations given in paragraph 2.
See also:
Coolant pump - removal and refitting
1 Disconnect the battery negative lead.
2 Drain the cooling system.
3 Proceed as follows according to model:
SOHC models
4 Disconnect the heater and radiator bottom
hoses from the coolant pump.
...
Steering column - removal and refitting
Removal
1 Set the front wheels in the straight-ahead
position.
2 Disconnect the battery negative lead.
3 Remove the driver’s side lower facia trim
panels.
4 Remove the screws and withdraw the
s ...
Air bag supplemental restraint system (SRS)
Important SRS precautions
The SRS is designed to work with
the safety belt to help protect the
driver and right front passenger
from certain upper body injuries. Air
bags DO NOT inflate slowl ...