Engine/manual gearbox assembly - reconnection and refitting
1.8 litre (R2A type)
1 Reverse the procedure described in Section
10, noting the following points.
2 Before attempting to reconnect the engine to the gearbox, check that the clutch friction disc is centralised. This is necessary to ensure that the gearbox input shaft splines will pass through the splines in the centre of the friction disc.
3 Check that the clutch release arm and bearing are correctly fitted, and lightly grease the input shaft splines.
4 Check that the engine adapter plate is correctly positioned on its locating dowels.
5 Reconnect the clutch cable to the release arm, ensuring that it is routed as noted during removal.
6 Fill the engine with the correct grade and quantity of oil.
7 Fill the cooling system.
8 Check and if necessary top-up the gearbox oil level.
9 Check and if necessary adjust the tension of the alternator drivebelt.
10 Adjust the throttle cable.
1.6 and 1.8 litre (R6A type) 11 Reverse the procedure described in Section 10, noting the points made above.
Ensure that the vehicle speed sensor wiring plug is reconnected.
See also:
Cargo area (P100 models) - removal and refitting
Note: A suitable lifting crane and tackle will be
required for this operation.
Removal
1 Disconnect the battery negative lead.
2 Remove the fuel filler cap, then drain the
fuel tank.
3 Remove th ...
Coolant renewal (Every 24 000 miles or 2 Years)
Cooling system draining
1 It is preferable to drain the system when the
coolant is cold. If it must be drained when hot,
release the pressure cap on the thermostat
housing (or expansion tank on la ...
Examination and renovation
Crankshaft, bearings, cylinder
bores and pistons
1 Refer to Section 13 in Part A of this Chapter.
The information applies equally to the CVH
engine, except that standard sized crankshafts
are unm ...