Engine/automatic transmission assembly - reconnection and refitting
1 Reverse the procedure described in Section 11, noting the following points.
2 Check that the engine adapter plate is correctly positioned on its locating dowels.
3 As the torque converter is only loosely engaged in the transmission, care must be taken to prevent the torque converter from falling out forwards. When the torque converter hub is fully engaged with the fluid pump drivegear in the transmission, distance “A” in illustration 2.24 of Chapter 7B must be as specified. Incorrect installation of the torque converter will result in damage to the transmission.
4 As the engine and transmission are reconnected, guide the torque converter studs through the holes in the driveplate.
When the engine is positioned flush with the engine adapter plate and the transmission housing, check that the torque converter is free to move axially a small amount before refitting and tightening the engine-totransmission bolts.
5 Do not tighten the torque converter-todriveplate nuts until the lower engine-totransmission bolts have been fitted and tightened.
6 Reconnect and adjust the selector rod.
7 Fill the engine with the correct grade and quantity of oil.
8 Fill the cooling system.
9 Check and if necessary top-up the transmission fluid level.
10 Check and if necessary adjust the tension of the alternator drivebelt.
11 Adjust the throttle cable.
12 Where applicable, adjust the kickdown cable.
See also:
Starter motor brushes - renewal
1 Starter motor brush renewal is a relatively
difficult procedure, requiring skill in the use of
a soldering iron. It should also be borne in
mind that if the starter motor has been in
service lon ...
Auxiliary shaft - removal, inspection and refitting
Note: A new gasket should be used when
refitting the auxiliary shaft cover (see text).
Removal
1 Remove the timing belt and the auxiliary
shaft sprocket.
2 Remove the distributor.
3 Remove the m ...
Oil pump - removal and refitting
Note: A suitable puller will be required to
remove the crankshaft pulley. A new
crankshaft pulley bolt, a new lower timing
chain cover gasket, and a new oil pump
gasket, must be used on refitting. ...