Heater motor - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 Where necessary, unclip the brake servo vacuum hose for improved access.
3 On models from 1987, unclip the windscreen washer hoses and wiring from the motor cover, and secure them to the bodywork out of the way.
4 Unscrew the two securing bolts from the motor cover, pull off the rubber moulding, then withdraw the cover (see illustration).
20.4 Unscrew the securing bolts and withdraw the heater motor cover
5 Disconnect the wiring from the motor, and detach the earth lead from its bracket.
6 Unscrew the two motor securing nuts, and withdraw the motor assembly (see illustration).
20.6 Heater motor and wiring
7 Unclip the casing halves, then prise open the motor retaining strap using a screwdriver, or if necessary a drift.
8 Detach the wiring from the motor, then remove the motor and fan wheels from the casing.
Refitting
9 Refitting is a reversal of removal.
See also:
Front suspension lower arm inner pivot bush - renewal
1 To improve access, raise the front of the
vehicle on ramps. Apply the handbrake.
2 Unscrew and remove the nut, washer and
pivot bolt securing the relevant lower arm to
the crossmember.
3 Remove ...
Engine/manual gearbox assembly - removal and separation
Note: A suitable hoist and lifting tackle will be
required for this operation.
1.8 litre (R2A type)
Removal
1 Proceed as described in Section 8,
paragraphs 1 to 15 inclusive.
2 Working inside th ...
Minor body damage - repair
Note: For more detailed information about
bodywork repair, Haynes Publishing produce
a book by Lindsay Porter called ”The Car
Bodywork Repair Manual”. This incorporates
information on such aspects ...
