Fuel system (1.6 and 1.8 litre (R6A type) CVH) - depressurisation
Remember to depressurise the fuel system before loosening any connections.
Refer to the precautions in Section 1 before proceeding. The fuel system will remain pressurised after the engine is switched off.
1 Disconnect the battery negative lead.
2 Remove the air cleaner assembly.
3 Position a suitable container (or a sufficient quantity of absorbent cloth) beneath the fuel inlet connection on the CFI unit.
4 Use an open-ended spanner on the flats of the inlet union screwed into the CFI unit, to prevent it from turning while the inlet pipe union is loosened (see illustration). Allow all pressure/fuel seepage to dissipate before fully unscrewing the union if it is to be disconnected, or tightened if another part of the system is to be worked on.
4.4 CFI unit fuel inlet union (arrowed)
5 The system will remain depressurised until the fuel pump is primed prior to starting the engine. Remove the container or cloth, as applicable, on completion.
Fuel filter - renewal
Refer to Chapter 1, Section 41.
See also:
Heater controls - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 Remove the securing screws and unclip the
lower and upper steering column shrouds.
3 Remove the four securing screws and
withdraw the instrument ...
Rear suspension leaf spring (P100 models) - removal and refitting
Note: All self-locking nuts and spring washers
must be renewed on reassembly.
Removal
1 Chock the front wheels, jack up the rear of
the vehicle and support on axle stands placed
under the side me ...
Starter motor - testing in the car
Note: Refer to the precautions given in
“Safety first!” and in Section 1 of this Chapter
before proceeding.
1 If the starter motor fails to operate when the
ignition key is turned to the appropria ...