Rear suspension front mounting (Saloon, Hatchback and Estate models) - renewal
1 Chock the front wheels, jack up the rear of the vehicle and support on axle stands placed under the side members.
2 Unscrew and remove the three bolts securing the relevant front guide plate to the underbody and the suspension crossmember.
Where applicable, bend back the lockwasher tab(s) on the larger bolt.
3 Using a length of wood, lever the suspension crossmember downwards a few inches from the underbody, and insert the wood as a wedge.
4 Using a tool similar to the Ford special tool shown (see illustration), or a long bolt with nut, washers and a suitable metal tube, pull the mounting rubber from the crossmember.
15.4 Ford special tool 15-014 for removing rear suspension front mounting
rubber
5 Lubricate the new mounting rubber with soapy water, and use the tool described in the previous paragraph to press the rubber into the crossmember.
6 Further refitting is a reversal of removal.
Where applicable, secure the larger front guide plate bolt by bending up the lockwasher tab(s).
See also:
General information
The 1.1 litre, 1.3 litre, 1.4 litre and 1.6 litre
CVH (Compound Valve angle, Hemispherical
combustion chambers) engines are of four
cylinder in-line overhead camshaft type,
mounted transversely, t ...
Loudspeakers - removal and refitting
Facia mounted loudspeaker
Removal
1 Carefully prise up the speaker grille using a
small screwdriver. Lift it from the facia.
2 Extract the speaker mounting screws which
are now exposed.
3 Lift t ...
Timing belt - removal, refitting and adjustment
Removal
Note: From April 1988 (build code JG) a
modified timing belt tensioner incorporating a
larger diameter tensioner roller was
introduced, and from October 1988 an
improved timing belt was u ...