Rear anti-roll bar (Saloon, Hatchback and Estate models) - removal and refitting
Removal
1 Loosen the rear roadwheel nuts, chock the
front wheels, jack up the rear of the vehicle
and support on axle stands placed under the
side members.
2 Prise off the straps which connect the anti-roll bar to the suspension lower arms (see illustration).
17.2 Anti-roll bar-to-lower arm connecting strap
3 Unbolt the two securing brackets from the underbody, and remove the anti-roll bar (see illustration).
17.3 Anti-roll bar-to-underbody securing bracket
4 The connecting straps can be prised from the ends of the anti-roll bar, and the underbody mounting brackets and rubbers, which are of a split design, can be pulled off.
5 When fitting new mounting components, lubricate the rubber parts with soapy water to ease assembly.
Refitting
6 Refitting is a reversal of removal. Tighten
the anti-roll bar-to-underbody securing bolts
to the specified torque.
See also:
Handbrake - adjustment
1 Adjustment of the handbrake is normally
automatic by means of the self-adjusting
mechanism working on the rear brake shoes.
2 However, due to cable stretch, occasional
inspection of the handbrak ...
Accelerator pedal - removal and refitting
Removal
1 The pedal can be removed once the throttle
cable has been disconnected from it as
described in Section 7.
2 Undo the two pedal support bracket
retaining bolts and remove the pedal.
Ref ...
Electrical fault finding - general information
Note: Refer to the precautions given in
“Safety first!” and in Section 1 of this Chapter
before starting work. The following tests relate
to testing of the main electrical circuits, and
should not ...