Steering wheel - removal and refitting
Removal
1 Set the front wheels in the straight-ahead
position.
2 Prise the trim insert from the centre of the steering wheel, and where applicable, disconnect the horn electrical lead(s) (see illustration).
22.2 Prise off the steering wheel trim insert and disconnect the horn
electrical lead
3 Insert the ignition key and check that the steering lock is disengaged.
4 Unscrew the retaining nut and withdraw the steering wheel from the hexagon shaped inner column (see illustration). If the wheel is tight on the inner column, sit in the driver’s seat and tap the wheel from behind with the palms of the hands (but screw the nut back on two or three turns for safety).
22.4 Removing the steering wheel retaining nut
Refitting
5 Refitting is a reversal of removal, but check
that the lug on the direction indicator cam is
aligned with the cut-out in the steering wheel,
and make sure that the direction indicator
switch is in the neutral position. Tighten the
retaining nut to the specified torque.
See also:
Heater motor - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 Where necessary, unclip the brake servo
vacuum hose for improved access.
3 On models from 1987, unclip the
windscreen washer hoses and wiring fro ...
Door handle and lock components - removal and refitting
Door exterior handle
Removal
1 Remove the door trim panel (Section 11).
2 Peel back the waterproof sheet as
necessary to gain access (see illustration).
13.2 Peel back the waterproof sheet for ...
Throttle housing - removal and refitting
Note: During manufacture the throttle plate is
adjusted so that it is fractionally open, to avoid
the possibility of it jamming shut, and it must
not be repositioned. Idle speed adjustment is
prov ...