Boot lid lock (Saloon models) - removal and refitting
Removal
1 With the boot lid raised, remove the lock
barrel retaining clip.
2 Where applicable, disconnect the operating lever from the central locking solenoid/motor, then withdraw the lock barrel.
3 Remove the three retaining screws from the lock assembly, if necessary loosening the reinforcing plate (see illustration).
Customize your watchlist and receive personalized recommendations from 123Movies.
10.3 Boot lid lock - Saloon models
A Lock retaining screws
B Earth lead
C Reinforcing plate screws
4 Where applicable, disconnect the battery negative lead, the earth lead from the bootlid and the “boot lid ajar” sensor wiring plug.
Unclip the luggage compartment light switch from the lock assembly, where applicable.
5 Withdraw the lock assembly from the boot lid.
Refitting
6 Commence refitting by inserting the lock
assembly and loosely refitting the retaining
screws.
7 Insert the lock barrel, where applicable reconnecting the operating lever to the solenoid, and refit the retaining clip.
8 Tighten the lock assembly retaining screws, and where applicable reconnect the earth lead and “boot lid ajar” sensor wiring plug, and the battery negative lead.
9 If the reinforcing plate was loosened during removal, tighten the retaining screws.
See also:
Pistons/connecting rods - removal and refitting
Removal
1 Remove the sump, as described in Section
8, and the cylinder head, as described in
Section 7.
2 Check that the connecting rod and cap
have adjacent numbers at their big-end to
indicate ...
Engine/manual gearbox assembly - reconnection and refitting
1.8 litre (R2A type)
1 Reverse the procedure described in Section
10, noting the following points.
2 Before attempting to reconnect the engine
to the gearbox, check that the clutch friction
disc ...
Exhaust manifold nut check - RS Turbo models (Every 6000 miles
or 6 months)
Check the tightness of the exhaust
manifold securing nuts using a torque wrench. ...