Door window regulator - removal and refitting
Removal
1 Remove the door inner trim panel.
2 Where necessary for improved access, peel back the waterproof plastic sheet from the door.
3 Lower the window until the lower support channel is visible through the lower door aperture. Prise the regulator arms from the sockets in the support channel, then lower the window to the bottom of the door (see illustration).
28.3 Front door window lower support channel and regulator arms
4 Drill out the four rivets securing the regulator assembly to the inner door skin, and if working on a front door, drill out the two rivets securing the regulator guide (see illustration).
28.4 Door window regulator fixings
A Front door
B Rear door
C Regulator assembly securing rivets
D Regulator guide rivets
5 On models with electric windows, disconnect the motor wiring plug after disconnecting the battery negative lead.
Removal and refitting of the motor is described in Chapter 13.
6 Withdraw the regulator assembly through the lower door aperture.
Refitting
7 Refitting is a reversal of removal, but fit new
rivets, using a hand riveter.
See also:
Air cleaner element renewal (Every 24 000 miles or 2 Years)
Carburettor and Central Fuel
Injection (CFI) models
1 To remove the air cleaner lid undo and
remove the retaining screws or bolts on the
top face of the lid (see illustrations).
34.1a Removing ...
Ford VV carburettor manual choke unit - removal, checking and
refitting
Note: A new gasket will be required on
refitting.
Removal
1 Disconnect the battery negative lead.
2 Remove the air cleaner (Section 2).
3 Slacken the choke cable clamp bolt at the
choke lever, d ...
Accelerator pedal - removal and refitting
Removal
1 The pedal can be removed once the throttle
cable has been disconnected from it as
described in Section 7.
2 Undo the two pedal support bracket
retaining bolts and remove the pedal.
Ref ...