Inner gutter weatherstrip (Saloon, Hatchback and Estate models) - removal and refitting
Removal
1 Open both the front and rear doors to
expose the relevant weatherstrip.
2 Carefully pull the weatherstrip from the base of the front pillar, taking care to release the flap which is stuck to the pillar with adhesive.
3 Pull the remainder of the weatherstrip from its flange.
4 Carefully clean the old adhesive from the base of the front pillar using methylated spirits.
Refitting
5 Commence refitting by pushing the
weatherstrip onto its flange at the top corner
of the rear pillar, running it for approximately
200 mm (8.0 in) along the horizontal flange.
6 Align the flap on the front pillar, and apply a thin bead of rubber-based adhesive to the flap. Refit the flap to the front pillar, ensuring that it lies naturally. Should the flap not lie naturally, or start to lift, temporarily secure it in position with adhesive tape.
7 Refit the remainder of the weatherstrip, starting at the front pillar and working rearwards, then close the doors and allow the adhesive to dry for at least an hour.
See also:
Radio aerial (exteriormounted) - removal and refitting
1 On models fitted with an electric aerial,
disconnect the battery negative lead.
Saloon and Estate models
2 Remove the right-hand side trim panel from
the luggage compartment.
3 Working outside ...
General description
The independent front suspension is of the
MacPherson strut type, incorporating coil
springs and integral telescopic shock
absorbers. Lateral location of each strut
assembly is by a forged or pres ...
Seat belts - removal and refitting
Front seat belt stalk
1 Remove the front seat.
2 Detach the seat belt stalk from the seat by
removing the two Torx screws.
3 Refitting is a reversal of removal.
Front seat belt assembly
4 Where ...