Headlamp wiper motor - removal and refitting
Note: On vehicles fitted with foglamps, the headlamp unit must be removed when the righthand headlamp wiper motor is to be removed.
Removal
1 Disconnect the battery negative lead.
2 Disconnect the washer hose from the nozzle on the end of the wiper arm, then remove the wiper arm.
3 Pull the washer hose and retainer from the end of the motor shaft.
4 Remove the radiator grille panel.
5 Where applicable, prise the trim strip from the bottom of the headlamp unit for access to the wiper motor mounting bolts (see illustrations).
40.5a Prise the trim strip from the bottom of the headlamp unit . . .
40.5b . . . for access to the headlamp wiper motor mounting bolts
6 Remove the two mounting bolts, then working under the wheel arch, slide the wiper motor rearwards, disconnect the wiring plug and withdraw the motor.
Refitting
7 Refitting is a reversal of removal, but on
completion adjust the free length of the
washer hose between the nozzle and the
retainer on the motor shaft.
See also:
Intercooler - removal and refitting
1985 models
Removal
1 Disconnect the battery negative lead.
2 Remove the air cleaner as described in
Section 2.
3 Remove the intercooler upper and lower air
hoses (see illustration).
22.3 Int ...
Servicing your tires
Checking the tire pressure
Use an accurate tire pressure gauge.
Check the tire pressure when tires are cold, after the vehicle has been
parked for at least one hour or has been driven less tha ...
Safety restraints for children
See the following sections for directions on how to properly use safety
restraints for children. Also see Air bag supplemental restraint system
(SRS) in this chapter for special instructions about u ...