Headlamp unit - removal and refitting
1 Disconnect the battery negative lead.
2 Remove the radiator grille panel.
Models up to 1987
3 Disconnect the headlamp wiring plug(s)
see illustration).
41.3 Disconnect the headlamp wiring plug - models up to 1987
4 Remove the three or four headlamp securing bolts, as applicable, and the lower sliding clamp bracket bolt on the rear of the headlamp, then withdraw the headlamp (see illustrations).
41.4a Remove the upper headlamp securing bolts (arrowed) . . .
41.4b . . . the rear securing bolt . . .
41.4c . . . and the lower sliding clamp bracket bolt . . .
41.4d . . . then withdraw the headlamp unit - models up to 1987
5 If required, the headlamp lens can be removed by releasing the spring clips around its edge.
6 Refitting is a reversal of removal, but the headlamp securing bolts should not be tightened until the headlamp is aligned with the front grille panel.
7 On completion, check the headlamp alignment.
Models from 1987
8 Disconnect the headlamp wiring plug(s)
(see illustration).
41.8 Disconnect the headlamp wiring plug - models from 1987
9 Where applicable, remove the headlamp wiper motor.
10 Remove the headlamp securing bolt and the two nuts, then release the anchor spring and withdraw the direction indicator !amp unit (see illustrations).
41.10a Remove the headlamp rear securing bolt . . .
41.10b . . . the upper securing nut . . .
41.10c . . . and the side securing nut - models from 1987
11 Pull the headlamp forwards, then swivel it and remove it sideways.
12 If required, the headlamp lens can be removed by releasing the spring clips around its edge.
13 Refitting is a reversal of removal.
14 On completion, check the headlamp alignment.
See also:
Fuel tank - removal and refitting
Caution: Refer to the
precautions in Section 1 before
proceeding.
1 Run the fuel level as low as possible before
removing the tank.
2 Disconnect the battery negative lead.
3 Remove the tank fill ...
Radiator grille panel - removal and refitting
Models up to 1987
1 With the bonnet raised, remove the four
grille panel securing screws from the top of
the front panel.
2 Lift the grille panel from its lower mounting
bushes, and withdraw it f ...
Front anti-roll bar - removal and refitting
Removal
1 To improve access, raise the front of the
vehicle on ramps. Do not jack the vehicle up
at this stage. Apply the handbrake.
2 Where applicable bend back the locktabs,
then unscrew the tw ...