Loudspeakers - removal and refitting
1 Disconnect the battery earth lead.
Facia panel-mounted speakers
Upper
2 Prise the speaker grille from its four
retaining clips in the facia using a thin-bladed
screwdriver.
3 Remove the four securing screws, disconnect the wiring, and pull the loudspeaker from the facia panel.
4 Refitting is a reversal of removal.
Lower
5 Remove the lower facia panel.
6 Remove the four securing screws, disconnect the wiring, and pull the loudspeaker from the facia panel.
7 Refitting is a reversal of removal.
Rear parcel shelf-mounted
speakers
Saloon models
8 Working in the luggage compartment,
remove the single securing screw, then lift the
loudspeaker into the passenger compartment
and disconnect the wiring. Withdraw the
loudspeaker.
9 Note that it is important not to disturb the loudspeaker mounting gasket or retainer.
10 Refitting is a reversal of removal, but ensure that the wiring does not touch the retainer, shelf, or speaker, to prevent any audible rattles.
Hatchback models
11 Working under the parcel shelf, remove
the four securing screws, disconnect the
wiring, and withdraw the loudspeaker.
12 Refitting is a reversal of removal.
Door-mounted speakers
13 Remove the door inner trim panel.
14 Remove the four securing screws, then withdraw the loudspeaker from the door and disconnect the wiring. Remove the loudspeaker.
15 Do not remove the loudspeaker from the moulding, as the two are a sealed assembly.
16 Refitting is a reversal of removal.
Tailgate-mounted speakers -
Estate models
17 Remove the tailgate trim panel.
18 Remove the four securing screws, disconnect the wiring and withdraw the loudspeaker. Note that on models with an integral heated rear window/radio aerial, the aerial amplifier unit is combined with one of the loudspeaker units.
19 Refitting is a reversal of removal.
High frequency units
20 These units are used to reproduce high
frequencies only, and incorporate an
electronic filter network which must not be
disconnected or bypassed. The units are
located in the lower facia panels.
21 The removal and refitting procedure is as described for the lower facia panel-mounted loudspeakers earlier in this Section, but take care not to damage the extremely fragile speaker cones.
Radio/cassette player power amplifier - removal and refitting
Removal
1 Some “high specification” models are fitted
with an audio power amplifier, which is
mounted as a separate unit beneath the radio/
cassette unit. To remove the unit proceed as
follows.
2 Disconnect the battery negative lead.
3 Remove the two screws under the top edge of the power amplifier unit.
4 Slide the unit forwards from the facia panel, until the wiring plugs can be disconnected.
Disconnect the wiring plugs and remove the unit.
Refitting
5 Refitting is a reversal of removal.
See also:
Steering wheel - removal and refitting
Removal
1 Set the front wheels in the straight-ahead
position.
2 Prise the trim insert from the centre of the
steering wheel, and where applicable,
disconnect the horn electrical lead(s) (see
il ...
Light laden valve (Van models) - adjustment, removal and
refitting
1 The light laden valve used on Van models is
a pressure regulating valve which reacts to
suspension height according to vehicle load.
The valve is mounted on the underside of the
vehicle above th ...
Flywheel/driveplate - removal, inspection and refitting
Note: New flywheel securing bolts must be
used on refitting.
1.8 litre (R2A type)
1 Refer to Section 26, Chapter 2, Part A but
also note the following points.
2 The flywheel/driveplate securing b ...