Multi-function lever

Windshield wiper:

  • For intermittent wiping, move the control down one position and rotate the wiper switch to the desired position.
  • For low speed wiping, move the control down two positions.
  • For high speed wiping, move the control down three positions.

Windshield washer:


Windshield washer:

  • For mist wiping, move the control up one position.
  • To spray the washer fluid, pull the wiper control toward you.

Changing the wiper blades


Changing the wiper blades

1. Pull the wiper arm away from the vehicle. Turn the blade at an angle from the wiper arm. Push the lock pin manually to release the blade and pull the wiper blade down toward the windshield to remove it from the arm.

2. Attach the new wiper to the wiper arm and press it into place until a click is heard.

3. Replace wiper blades every 6 months for optimum performance.

TILT STEERING (IF EQUIPPED)


TILT STEERING (IF EQUIPPED)

Pull the tilt steering control down to move the steering wheel up or down. Hold the control while adjusting the wheel to the desired position, then push the control back up to lock the steering wheel in position.

Never adjust the steering


Never adjust the steering wheel when the vehicle is moving.

POWER WINDOWS (IF EQUIPPED)

When closing the power windows, you should verify they are free of obstructions and ensure that children and/or pets are not in the proximity of the window openings. Press and hold the bottom part of the rocker switch to open the window.


Press and hold the bottom part of the rocker switch to open the window.

Press and hold the top part of the rocker switch to close the window.

One touch down

Allows the driver's window to open fully without holding the control down. Press completely down on the bottom part of the rocker switch and release quickly. Press again to stop. POWER SIDE VIEW MIRRORS (IF EQUIPPED)


POWER SIDE VIEW MIRRORS (IF EQUIPPED) To adjust your mirrors


To adjust your mirrors

1. Select L to adjust the left mirror or R to adjust the right mirror.

2. Move the control in the direction you wish to tilt the mirror.

3. Return to the center position to disable the adjust function.

    See also:

    Engine/manual gearbox assembly - reconnection and refitting
    1.8 litre (R2A type) 1 Reverse the procedure described in Section 10, noting the following points. 2 Before attempting to reconnect the engine to the gearbox, check that the clutch friction disc ...

    Rear suspension angles - general
    The rear wheel toe and camber angles are set in production and do not require checking under normal service conditions. Of the two, only the toe setting can be adjusted, the camber angle being fix ...

    General information and precautions
    The fuel system on all models with carburettor induction is composed of a centrally mounted fuel tank, a fuel pump, a carburettor and an air cleaner. The fuel tank is mounted under the floor pan ...