Identifying components in the engine compartment
2.0L DOHC Zetec engine
- Transmission fluid dipstick (automatic transaxle)
- Battery
- Air filter assembly
- Engine oil filler cap
- Engine oil dipstick
- Power steering fluid reservoir
- Engine coolant reservoir
- Windshield washer fluid reservoir
- Brake fluid reservoir
WINDSHIELD WASHER FLUID
Check the washer fluid whenever you stop for fuel. The reservoir is highlighted with a symbol.
If the level is low, add enough fluid to fill the reservoir. In very cold weather, do not fill the reservoir all the way.
Only use a washer fluid that meets Ford specifications. Refer to Lubricant specifications in this chapter.
State or local regulations on volatile organic compounds may restrict the use of methanol, a common windshield washer antifreeze additive.
Washer fluids containing non-methanol antifreeze agents should be used only if they provide cold weather protection without damaging the vehicle's paint finish, wiper blades or washer system.
If you operate your vehicle in temperatures below 4.5º C (40º F), use washer fluid with antifreeze protection. Failure to use washer fluid with antifreeze protection in cold weather could result in impaired windshield vision and increase the risk of injury or accident.
Note: Do not put washer fluid in the engine coolant reservoir. Washer fluid placed in the cooling system may harm engine and cooling system components.
See also:
Doors - removal and refitting
Front door
Pre-1986 models
Removal
1 Open the door fully and support its lower
edge on a jack or blocks covered with a pad
of cloth to prevent scratching.
2 Unscrew the two bolts which hold the
...
Fuel system (1.6 and 1.8 litre (R6A type) CVH) - depressurisation
Remember to depressurise the
fuel system before loosening any
connections.
Refer to the precautions in
Section 1 before proceeding. The fuel
system will remain pressurised after the
engine is sw ...
Rear disc caliper - removal, overhaul and refitting
Note: Complete dismantling of the rear caliper
should not be attempted unless Ford spring
compressor (tool No 12-007) is available, or
unless the problems likely to arise in the
absence of the too ...