See also:

Engine/manual gearbox assembly - removal and separation
Note: A suitable hoist and lifting tackle will be required for this operation. 1.8 litre (R2A type) Removal 1 Proceed as described in Section 8, paragraphs 1 to 15 inclusive. 2 Working inside th ...

Cab interior trim panels (P100 models) - removal and refitting
Side trim panel 1 Remove the rear pillar trim panel. 2 Remove the side trim panel by prising out the four expander pins from the clips, then pulling out the clips and withdrawing the panel. 3 Re ...

Timing belt and sprockets - removal and refitting
Note: Refer to the warning in Section 8 before proceeding. On models from mid-1985 (without a timing belt tensioner spring) the belt tension should be checked using Ford special tool No 21-113 aft ...