Brake components check (Every 36 000 miles or 3 years)
1 Inspect the thickness of the friction linings on the disc pads and brake shoes (as described earlier in this Chapter) at the intervals specified.
2 The rigid and flexible hydraulic pipes and hoses should be inspected for leaks or damage regularly. Although the rigid lines are plastic-coated in order to preserve them against corrosion, check for damage which may have occurred through flying stones, careless jacking or the traversing of rough ground.
3 Bend the hydraulic flexible hoses sharply with the fingers and examine the surface of the hose for signs of cracking or perishing of the rubber. Renew if evident.
4 Renew the brake fluid at the specified intervals and examine all rubber components (including master cylinder and piston seals) with a critical eye, renewing where necessary.
See also:
Accelerator pedal - removal and refitting
The procedure is the same as described in
Part A of this Chapter for carburettor models. ...
Minor body damage - repair
Repair of minor scratches in
bodywork
If the scratch is very superficial, and does not
penetrate to the metal of the bodywork, repair is
very simple. Lightly rub the area of the scratch
with a pa ...
Fuel injector (1.6 and 1.8 litre (R6A type) CVH) - removal and refitting
Caution: Refer to the
precautions in Section 1 before
proceeding.
1.6 litre
Note: New fuel injector seals must be used on
refitting.
1 Disconnect the battery negative lead.
2 Remove the air cle ...