Major operations requiring engine removal
The following work can only be carried out after removal of the engine from the car: a) Crankshaft main bearings - renewal .
b) Crankshaft - removal and refitting.
c) Flywheel - removal and refitting.
d) Crankshaft rear oil seal - renewal.
e) Camshaft - removal and refitting.
f) Timing gears and chain - removal and refitting.
See also:
Radiator grille - removal and refitting
Pre-1988 models
Removal
1 The grille is held in position by four spring
clips (see illustration).
10.1 Radiator grille spring clip - pre-1988 models
2 Once these clips are released, the grille ...
Fuel pump - removal and refitting
The fuel pump is integral with the fuel level
sender unit in the fuel tank. Removal and
refitting are as described in Part C of this
Chapter for models with the CFI system. ...
Switches - removal and refitting
General
1 Disconnect the battery negative terminal
before removing any switches.
Pre-1986 models
Wiper delay switch
2 Remove the switch knob and the bezel nut.
3 Withdraw the switch through the ...