Oil pump - removal and refitting
Note: A new gasket must be used on refitting.
Removal
1 The oil pump is externally mounted on the
rear facing side of the crankcase.
2 Using a strap wrench or similar, unscrew and remove the oil filter cartridge and discard it.
3 Unscrew the three mounting bolts and withdraw the oil pump from the engine (see illustration).
10.3 Removing the oil pump
4 Clean away the old gasket.
Refitting
5 If a new pump is being fitted. it should be
primed with engine oil before installation. Do
this by turning its shaft while filling it with
clean engine oil.
6 Locate a new gasket on the pump mounting flange, insert the pump shaft and bolt the pump into position.
7 Grease the rubber sealing ring of a new filter and screw it into position on the pump, using hand pressure only, not the removal tool.
8 Top-up the engine oil to replenish any lost during the operations.
See also:
Essentials of good fuel economy
Measuring techniques
Your best source of information about actual fuel economy is you, the
driver. You must gather information as accurately and consistently as
possible. Fuel expense, frequency of ...
Headlamp unit - removal and refitting
1 Disconnect the battery negative lead.
2 Remove the radiator grille panel.
Models up to 1987
3 Disconnect the headlamp wiring plug(s)
see illustration).
41.3 Disconnect the headlamp wiring plu ...
Fuel-injection control module - removal and refitting
Removal
1 The fuel-injection control module is only
used on KE-Jetronic systems and is located in
the engine compartment behind the heater
plenum chamber and fan motor.
2 Disconnect the battery n ...