Horn - removal and refitting
Removal
1 The horn(s) are located in the left-hand front
corner of the engine compartment. Before
removing, disconnect the battery.
2 Disconnect the lead from the horn.
3 Unscrew the single bolt and remove the horn and bracket.
Refitting
4 Refitting is a reversal of removal.
See also:
Electrical fault finding - general information
Note: Refer to the precautions given in
“Safety first!” and in Section 1 of this Chapter
before starting work. The following tests relate
to testing of the main electrical circuits, and
should not ...
Wheel sensor (ABS) - removal and refitting
Note: A new O-ring must be used when
refitting a sensor.
Front wheel sensor
1 Apply the handbrake, loosen the relevant
front roadwheel nuts, then jack up the front of
the vehicle and support on a ...
Cylinder head - removal and refitting (engine in vehicle)
Note: Refer to the warning at the beginning of
Section 5 and the note at the beginning of the
following Section before proceeding. The
cylinder head must not be removed when the
engine is warm.
R ...
