Heated rear window aerial amplifier - removal and refitting
Removal
1 On some 1986 models onwards the radio
aerial is incorporated in the heated rear
window element, and to assist reception an
amplifier is fitted. This is located in the tailgate
adjacent to the tailgate wiper motor. Removal
and refitting is as follows.
2 Remove the tailgate wiper motor trim panel and the adjoining trim panel.
3 Undo the two screws and withdraw the amplifier.
4 Disconnect the wiring and remove the amplifier.
Refitting
5 Refitting is a reversal of removal.
See also:
EEC IV system components - removal and refitting
Note: Procedures for removal and refitting of
the ignition system components and
electronic module are given elsewhere in the
relevant Sections of this Chapter.
Engine coolant temperature
sensor
...
Hydraulic system - bleeding (conventional braking system)
Note: On cars equipped with the Anti-lock
Braking System, refer to Section 23.
Warning: Hydraulic fluid is
poisonous; wash off immediately
and thoroughly in the case of skin
contact, and seek imm ...
Speed sender unit - removal and refitting
The speed sender unit is similar to that
used with the fuel computer described in
Chapter 12. ...
