See also:

EEC IV system components - removal and refitting
Note: Procedures for removal and refitting of the ignition system components and electronic module are given elsewhere in the relevant Sections of this Chapter. Engine coolant temperature sensor ...

Fuel-injection control module - removal and refitting
Removal 1 The fuel-injection control module is only used on KE-Jetronic systems and is located in the engine compartment behind the heater plenum chamber and fan motor. 2 Disconnect the battery n ...

Auxiliary warning system components - removal and refitting
General 1 This system monitors the fluid levels and front brake pads for excessive wear. In the event of a fluid level dropping below the specified level, or the brake pads wearing down to the mi ...