Disarming the engine immobiliser

Switching on the ignition disarms the system if the correct code is recognised.

The indicator illuminates for approximately three seconds and then extinguishes.

If the indicator illuminates constantly for one minute or flashes for approximately one minute and then repeatedly at irregular intervals, the system did not recognise the key code or a system fault is present. Remove the key and try again.

If the engine does not start, a system malfunction has occurred. Have the system checked by an expert immediately.

    See also:

    Engine block heater (if equipped)
    WARNING: Failure to follow engine block heater instructions could result in property damage or physical injury. WARNING: To reduce the risk of electrical shock, do not use your heater with ungrou ...

    Towing points
    Front towing eye Rear towing eye Note: On vehicles with a tow bar, the towing eye cannot be installed at the rear of the vehicle. Use the tow bar to tow a vehicle. Towing eye location The ...

    Air Charge Temperature (ACT) sensor - removal and refitting
    Removal 1 The ACT sensor is screwed into the CFI unit. 2 Disconnect the battery negative lead. 3 Remove the air cleaner assembly. 4 Disconnect the ACT sensor wiring plug (see illustration). 1 ...