Deceleratio sensitive valve (all models with conventional braking system) - removal and refitting
Caution: Refer to the precautions in Section 1.
Removal
1 The deceleration sensitive valve is located on the left-hand side of the engine compartment (see illustrations).
23.1a Early type deceleration sensitive valve
23.1b Later type deceleration sensitive valve
2 Place a suitable container beneath the valve to catch spilt fluid, then unscrew the union nuts and disconnect the fluid pipes.
Plug the open ends of the pipes and valve to prevent fluid leakage and dirt ingress. If fluid is accidentally spilt on the paintwork, wash off immediately with cold water.
3 On early models, the valve is secured to the mounting bracket on the inner wing by a single bolt. Unscrew the bolt and remove the valve.
4 On later models, the valve is secured to the mounting bracket by a clip. Remove the clip and slide out the valve.
Refitting
5 Refitting is a reversal of removal, but note that the early type of
valve must be fitted with the cover bolts facing forwards, and the later
type of valve must be fitted with the smaller diameter stepped end
facing forwards.
6 On completion, bleed the rear hydraulic circuit.
See also:
Bulbs (interior lamps) - renewal
Pre-1986 models
Glove compartment lamp
1 This is simply a matter of gently pulling the
bulb from its holder.
Heater control illumination lamp
2 Slide the heater control levers to the top of
thei ...
Headlining - removal and refitting
Saloon, Hatchback and Estate
models
1 On Saloons, remove the rear seat back.
2 Loosen the upper screws of all the pillar
trim panels touching the headlining.
3 Prise off the covers and remove the ...
Central (single-point) Fuel Injection (CFI) system
The system is best described by dividing it into four separate
sub-systems: air, fuel, engine management (EEC IV system), and ignition. ...