Changing a bulb

WARNINGS:
Switch the lights and the ignition off.

Let the bulb cool down before removing it.

CAUTIONS:
Do not touch the glass of the bulb.

Only fit bulbs of the correct specification. See Bulb
specification chart.

Note: The following instructions describe how to remove the bulbs. Fit replacement in the reverse order unless otherwise stated.

Headlamp main and dipped beam

1. Remove the headlamp. See Removing a headlamp.

2. Remove the cover.


2. Remove the cover.

3. Disconnect the electrical connector.

4. Release the clip and remove the bulb.

Side lamps

1. Remove the headlamp. See Removing a headlamp.

2. Remove the cover.


2. Remove the cover.

3. Carefully prise out the bulb holder.

4. Remove the bulb.

Front direction indicators

1. Remove the headlamp. See Removing a headlamp.

2. Turn the bulb holder anticlockwise and


2. Turn the bulb holder anticlockwise and remove it.

3. Gently press the bulb into the bulb holder, turn it anticlockwise and remove it.

Side repeaters

1. Carefully remove the side repeater.


1. Carefully remove the side repeater.

2. Hold the bulb holder, turn the housing anticlockwise and remove it.

3. Remove the bulb.

Front fog lamps
Front fog lamps

1. Disconnect the electrical connector.

2. Turn the bulb holder anticlockwise and remove it.

Rear lamps

1. Open the tailgate.

2. From inside the luggage


2. From inside the luggage compartment, remove the wing nut on the back of the rear lamp.

3. Remove the screws and remove the rear lamp assembly.

4. Release the clips and remove the bulb holder.

5. Gently press the bulbs into the bulb


5. Gently press the bulbs into the bulb holder, turn them anticlockwise and remove them.

Central high mounted stop lamp

1. Open the tailgate.


1. Open the tailgate.

2. Remove the rubber grommet.

3. Release the clips using a flat-bladed screwdriver and remove the lamp.

4. Unclip the bulb holder and remove the bulb.

Number plate lamp

1. Loosen the screws and remove the


1. Loosen the screws and remove the lamp.

2. Remove the bulb.

Interior lamp


1. Carefully prise out the lamp.


1. Carefully prise out the lamp.

2. Remove the lens.

3. Remove the bulb.

Reading lamps


1. Carefully prise out the lamp.


1. Carefully prise out the lamp.

2. Turn the bulb holder anticlockwise and remove it.

3. Remove the bulb.

Luggage compartment lamp

1. Carefully prise out the lamp.


1. Carefully prise out the lamp.

2. Remove the bulb.

    See also:

    Four Wheel Drive (4WD) System (if equipped)
    WARNING: For important information regarding safe operation of this type of vehicle, see Preparing to drive your vehicle in this chapter. Your vehicle is equipped with an intelligent 4WD System th ...

    Camshaft - removal and refitting
    Carburettor engines Note: Thread locking compound will be required to coat the camshaft sprocket bolt on refitting. Removal 1 Disconnect the battery negative lead. 2 Refer to the relevant Part o ...

    Timing belt - removal, refitting and adjustment
    Removal Note: From April 1988 (build code JG) a modified timing belt tensioner incorporating a larger diameter tensioner roller was introduced, and from October 1988 an improved timing belt was u ...