Tailgate/boot lid/fuel filler flap release cable - removal and refitting

Removal
1 Operate the control lever to open the tailgate/boot lid and the fuel filler flap (see illustration).

14.1 Tailgate/boot lid/fuel filler flap control lever assembly
14.1 Tailgate/boot lid/fuel filler flap control lever assembly

2 Remove the driver’s side centre pillar lower trim panel and the sill trim panel.

3 Withdraw the cover from the control lever.

4 Unscrew the two securing bolts, and detach the control lever assembly from the body panel. Detach the cable from the control assembly.

5 Fold the rear seat cushion forwards or remove it, as applicable, and remove the rear seat side cushion for access to the wheel arch trim panel.

6 Detach the trim panel from the wheel arch by removing the two securing screws from the parcel shelf bracket. Free the cable up to the wheel arch.

7 Working inside the luggage compartment, remove the trim panels for access to the petrol flap lock and tailgate/boot lid lock.

8 Disengage the petrol flap catch from the housing by twisting and pulling out (see illustration). Carefully pull the cable through into the luggage compartment, noting its routing.

14.8 Disengaging the petrol flap catch from the housing
14.8 Disengaging the petrol flap catch from the housing

9 Remove the securing screws, and withdraw the tailgate/boot lid lock striker from the body panel. Withdraw the striker and cable assembly.

Refitting
10 Commence refitting by installing the tailgate/boot lid striker and cable assembly.

Secure the cable to the body with tape.

11 Route the cable back to the petrol flap housing, and refit the petrol flap catch.

12 Route the cable into the interior of the vehicle, and refit the luggage compartment trim panels.

13 Route the cable to the control lever, securing the cable with tape to the body, then refit the wheel arch trim panel, and refit the seat cushions.

14 Reconnect the cable to the control lever assembly, then refit the assembly.

15 Refit the control lever cover and the trim panels.

    See also:

    Electronic Fuel Injection (EFI) system
    From the 1990 model year, an Electronic Fuel Injection (EFI) system controlled by the Electronic Engine Control IV (EEC IV) system, and incorporating an Electronic Distributorless Ignition system ...

    Safety restraints for children
    See the following sections for directions on how to properly use safety restraints for children. Also see Airbag supplemental restraint system (SRS) in this chapter for special instructions about us ...

    Camshaft - removal and refitting
    Carburettor engines Note: Thread locking compound will be required to coat the camshaft sprocket bolt on refitting. Removal 1 Disconnect the battery negative lead. 2 Refer to the relevant Part o ...