Door lock barrel - removal and refitting

Removal
1 Remove the door inner trim panel.

2 Where necessary for access, peel back the waterproof plastic sheet from the door.

3 Remove the window channel extension screw from the bottom rear corner of the door, and withdraw the channel through the lower door aperture.

4 Working inside the door aperture, pull out the lock barrel retaining clip using pliers, then unhook the lock operating rod from the barrel, and withdraw the barrel from outside the door (see illustration).

20.4 Door lock barrel location. Retaining clip arrowed
20.4 Door lock barrel location. Retaining clip arrowed

Refitting
5 Refitting is a reversal of removal.

    See also:

    Crankshaft and bearings - examination and renovation
    1 Proceed as described in Chapter 2, Part A, noting the following. 2 Production bearing undersizes are indicated as follows: Yellow or red paint marks on crankshaft - standard-diameter main beari ...

    Auxiliary input (AUX IN) socket
    Note: For optimum performance when using any auxiliary device set the volume on the device high. This will reduce audio interference when charging the device via the vehicle power supply socket. ...

    Cargo area (P100 models) - removal and refitting
    Note: A suitable lifting crane and tackle will be required for this operation. Removal 1 Disconnect the battery negative lead. 2 Remove the fuel filler cap, then drain the fuel tank. 3 Remove th ...