Door mirror - removal and refitting

Manually-operated mirror 1 On remote-control type mirrors, unscrew the bezel from the adjuster knob (see illustration).

29.1 Unscrew the bezel from the adjuster knob . . .
29.1 Unscrew the bezel from the adjuster knob . . .

2 Prise the mirror trim panel from the door (see illustration).

29.2 . . . and prise the mirror trim panel from the door to reveal the 3
29.2 . . . and prise the mirror trim panel from the door to reveal the 3 mirror securing screws (2 arrowed)

3 Remove the three mirror securing screws, and withdraw the mirror by tilting its rear edge outwards and disengaging its front edge from under the window surround. Where applicable, withdraw the mirror control cable through the door.

4 To remove the mirror glass, proceed as follows according to model.

5 On high specification models with fixed (ie not remote control) mirrors, lever the glass assembly outwards to disengage it from the balljoint on the mirror glass mounting.

6 On low specification models with fixed (ie not remote control) mirrors, unclip the cover, then remove the securing screw and withdraw the glass assembly (see illustration).

29.6 Fixed door mirror assembly
29.6 Fixed door mirror assembly

7 On models with remote control mirrors, insert a thin screwdriver through the hole in the bottom of the mirror assembly, and whilst supporting the glass, release the locking ring (see illustration).

29.7 Manual remote control and electric door mirror glass removal
29.7 Manual remote control and electric door mirror glass removal

A Locking operation
B Unlocking operation
C Locating pegs
D Locking slots
E Locking ring

8 Refitting is a reversal of removal, but ensure that the front edge of the mirror is correctly located under the window surround.

Electric mirror
9 Disconnect the battery negative lead.

10 If working on the drivers side of models up to 1987, prise the mirror switch assembly from the door trim panel and disconnect the wiring plug.

11 If working on the drivers side of models from 1987, prise the securing screw cover from the mirror control panel, then remove the screw and withdraw the control panel.

Disconnect the wiring plug.

12 On models up to 1987, and when working on the passenger side of models from 1987, prise out the mirror trim panel.

13 Remove the three mirror securing screws, and withdraw the mirror by tilting its rear edge outwards and disengaging its front edge from under the window surround. Withdraw the wiring through the door.

14 To remove the mirror glass proceed as described in paragraph 7.

15 Refitting is a reversal of removal, but ensure that the front edge of the mirror is correctly located under the window surround.

    See also:

    Adding engine coolant
    When adding coolant, make sure it is a 50/50 mixture of engine coolant and distilled water. Add the mixture to the coolant reservoir, when the engine is cool, until the appropriate fill level is obt ...

    Thermostat - removal, testing and refitting
    OHV engines Note: A new gasket must be used on refitting. Removal 1 Drain the cooling system as described in Chapter 1. 2 Slacken the clips and disconnect the hoses at the thermostat housing (se ...

    Telephone setup
    Phonebook After start up access to the phonebook list can be delayed for several minutes, depending upon the size. Phonebook categories Depending on your phonebook entry, different categories ca ...