Horn - removal and refitting
Removal
1 The horn(s) is/are located in front of the
radiator beneath the front panel (see
illustration). The horn(s) may be located on
either side of the vehicle depending on model.
29.1 Horn location beneath front panel
2 Disconnect the battery negative lead.
3 Disconnect the wiring from the horn, then unscrew the securing nut and washer and withdraw the horn and bracket assembly complete.
4 Repeat the operations for the remaining horn where applicable.
Refitting
5 Refitting is a reversal of removal.
See also:
Cylinder head - removal and refitting (engine in vehicle)
Note: Refer to the note at the beginning of
Section 20 before proceeding.
1.8 litre (R2A type)
Removal
1 Disconnect the battery negative lead.
2 Drain the cooling system.
3 Disconnect the heater ...
Front hub carrier - removal and refitting
Note: A balljoint separator tool will be
required for this operation.
Removal
1 Loosen the relevant front roadwheel nuts,
apply the handbrake, jack up the front of the
vehicle and support on axle ...
Fuel injectors and injector delivery pipes - removal and
refitting
Note: Refer to the precautions at the end of
Section 1 before proceeding. It is important to
note that each injection supply pipe
connection in the distributor head has a screw
adjacent to it. The ...
