Rear number plate lamp - removal and refitting

1 Disconnect the battery negative lead.

Saloon, Hatchback and Estate models
2 To remove a lamp, simply prise it from the bumper using a thin-bladed screwdriver, and disconnect the wiring plug (see illustration).

47.2 Removing a rear number plate lamp - Saloon, Hatchback and Estate models
47.2 Removing a rear number plate lamp - Saloon, Hatchback and Estate models

3 Refitting is a reversal of removal.

P100 models
4 Working behind the rear crossmember, pull the wiring plug from its clip and disconnect it.

5 Pull the lamp cover from the rubber housing, then pull the rubber housing and the wiring from the crossmember.

6 Refitting is a reversal of removal.

    See also:

    Opening and closing the bonnet
    Opening the bonnet WARNING: To prevent damage to, or loss of the key, remove the key immediately after opening and swivel the Ford badge back. Note: On vehicles with keyless entry, use the spar ...

    Fuel level sender unit - removal and refitting
    Caution: Refer to the precautions in Section 1 before proceeding. A new seal must be used when refitting the sender unit. Saloon, Hatchback and Estate models All models except 2.0 litre DOHC 1 ...

    Tailgate/boot lid lock and cylinder - removal and refitting
    Removal 1 Remove the trim panel as described in Section 32. 2 Extract the lock cylinder retaining clip, disconnect the control rods and remove the cylinder. 3 Undo the three screws and detach th ...