Engine/manual gearbox assembly - reconnection and refitting

1 Reverse the procedure described in Section 11, noting the following points.

2 Before attempting to reconnect the engine to the gearbox, check that the clutch friction disc is centralised. This is to ensure that the gearbox input shaft splines will pass through the splines in the centre of the friction disc.

3 Check that the clutch release arm and bearing are correctly fitted, and lightly grease the input shaft splines.

4 Check that the engine adapter plate is correctly positioned on its locating dowels.

5 Refit the propeller shaft.

6 Refit the exhaust system.

7 Reconnect the clutch cable to the release arm, ensuring that it is routed as noted during removal.

8 Fill the engine with the correct grade and quantity of oil.

9 Fill the cooling system.

10 Check and if necessary top-up the gearbox oil level.

11 Check and if necessary adjust the tension of the alternator and where applicable the power steering pump drivebelt(s).

12 Adjust the throttle cable.

    See also:

    Auxiliary power sockets
    CAUTION: If you use the socket when the engine is not running, the battery may discharge. Note: You can use the socket to power 12 volt appliances that have a maximum current rating of 10 Ampere ...

    Compression test
    Refer to Section 5, Chapter 2, Part A. ...

    Autolock
    The autolock feature will lock all the doors, liftgate and liftgate window when: Х all doors are closed, Х the ignition is in the on position, Х you shift into any gear putting the vehicle in mo ...