Engine dismantling, examination, renovation and reassembly - general information

Dismantling
1 Refer to Chapter 2, Part A, Section 18, paragraphs 1 to 8 inclusive.

2 A suitable selection of splined and Torx sockets will be required to remove many of the bolts when dismantling the engine.

3 Before dismantling the main engine components, the following externallymounted ancillary components can be removed, with reference to the relevant Chapters of this Manual and the relevant Sections of this Chapter, where applicable.

Inlet manifold (and carburettor, if applicable) Exhaust manifold
Alternator.

Coolant pump, and thermostat Alternator/coolant pump drivebelt tensioner Distributor cap, HT leads and spark plugs Oil pressure warning lamp switch Crankshaft speed/position sensor Oil filter
Dipstick
Engine mounting brackets (if not already done) Crankcase ventilation pipe and hoses Clutch
Alternator mounting bracket.

Air conditioning compressor mounting bracket (where applicable).

Engine lifting brackets.

Examination and renovation 4 Refer to Chapter 2, Part A, Section 18, but note that the connecting rod bolts should be renewed on reassembly, and when renewing the cylinder head bolts, the latest type bolts with hexagonal heads should always be used.

Reassembly
5 Proceed as described in Chapter 2, Part A, Section 18, noting the following: 6 If they have been removed, new cylinder head bolts (both M11 and M8, of the latest type with hexagonal heads), flywheel bolts, and connecting rod bolts must be used.

    See also:

    Road test (Every 12 000 miles (20 000 km) or 12 months)
    Instruments and electrical equipment 1 Check the operation of all instruments and electrical equipment. 2 Make sure that all instruments read correctly, and switch on all electrical equipment in ...

    General information and precautions
    General information The fuel system on carburettor models may comprise a fuel tank, a fuel pump, a fuel pressure regulator and/or vapour separator, a downdraught carburettor and a thermostaticall ...

    Subcompact cars manuals
    A subcompact car is an American definition to indicate an automobile with a class size smaller than that of a compact car, usually not exceeding 165 inches (4,191 mm) in length, but larger than a micr ...